SLITTING OPERATIONS 2

 

In order to excel in our commitment to our customer quality requirement, the addition of the Pro Eco unit enables our production planning employees to dedicate all automotive exposed and surface critical material to the Alcos and all non-automotive to the Pro Eco. This strategy has added efficiencies largely to our plant scheduling, as well as gains in our product quality, ensuring our just-in-time customer service, along with our 100% on-time delivery requirements

 

 

 

1/4" PRO ECO 72" SLITTER WITH SINGLE RECOILER

 

HIGH-SPEED, 3 HEAD INJECTION SYSTEM WITH SHIMLESS TOOLING & GAMMA RAY GAUGE MONITOR
Material Incoming Material Quality Incoming Strip Crown	HRP&O, CRS, Galvanized, Aluminized To ASTM Standards Max. 2%
Shear Stress Yield Strength Strip Thickness Strip Width at Entry Strip Width at Exit Coil Weight at Entry Coil Weight at Exit Coil O.D. at Entry Coil O.D. at Exit Coil I.D. at Entry Coil I.D. at Exit	Max. 50,000 PSI Max. 50,000 PSI Max. 0.250 Ins. Max. 76 Ins. Max. 72 Ins. Max. 70,000 Lbs. Max. 70,000 Lbs. Max. 78 Ins. Max. 78 Ins. 20 - 24 Ins. 20 - 24 Ins.	Min. 30,000 PSI Min. 0.012 Ins. Min. 12 Ins. Min. 12 Ins. (Determined by Knife Setup) Min. 40 Ins. Min. 40 Ins.
Line Speed Electrical Supply Electrical Control Supply Air Supply Hydraulic Design Pressure Hydraulic Working Pressure Mode of Operation Set-Up Position Passline Height Line Direction Pay-Off Direction Rewind Direction	Constant High Speed, 1000 FPM Constant Low Speed, 500 FPM Recoiler Gear-In, Refer to Recoiler Specification 575/3/60 110/1/60 80 PSI 1600 PSI (1750 at Pump) 1500 PSI Tight Line, Slitter Assist & Full Loop Edge Reference, Edge & Centerline Running 58 Ins. (Approx.) Left to Right Over Unwind Over Rewind